A factory fabricated, insulated piping system for conveying high pressure saturated steam up to 250 psi and 400ºF. SHORT FORM SPECIFICATIONS 1.1 All underground pre-insulated steam pipe 3” – 12” shall be Thermal Pipe Systems, Inc. Super Temp-Tite® piping with Ring-Tite joints. 1.2 Steel carrier pipe shall meet the requirements of ASTM A-53 or A-106, Grade B. Each end of the carrier pipe shall be machined and metalized to provide a non-corrosive surface for the sealing rings. The metalizing shall be high nickel alloy applied to an excess thickness and then machined to the required outside diameter. 1.3 Each joint shall automatically provide for expansion and contraction through the sealing rings in the grooves of the bronze joining coupling. The sealing rings shall be stainless steel spring loaded molded and machined Teflon. Pipe must be assembled with the lubricant supplied by Thermal Pipe Systems, Inc. 1.4 Casing pipe shall be fiberglass Reinforced Thermosetting Resin Pipe (RTRP) manufactured by a filament winding process. The pipe shall be wound to meet ASTM D2310 classified RTRP-12E. 1.5 The composite insulation shall be a two- component system. The initial insulation shall be Calcium Silicate satisfactory for temperatures to 1200ºF and shall conform to ASTM C-533 and MIL SPEC Mil-1-2781. The secondary insulation shall be polyurethane foam completely filling the void between the Calcium Silicate and casing. 1.6 The rubber end seals shall be a Highly Saturated Hitrile (HSN) or Ethylene Propylene Diene Monomer (EPDM) heat resistant compound. 1.7 Fittings shall be pre-insulated by Thermal Pipe Systems, Inc. using the same carrier pipe, insulation thickness, and casing as the straight lengths of pipe. Warranty We warrant that our products are manufactured with the applicable material specifications and are free from defects in the workmanship and material using our specifications as a standard. Every claim under this warranty shall be deemed waved unless in writing received by Thermal Pipe systems, Inc. within (30) days of the date the defect was discovered and within (1) year of the date of shipment of the product. Thermal Pipe Systems, Inc. MAKES NO REPRESENTATION OR WARRANTY OF ANY KIND, EXPRESSED OR IMPLIED, IN FACT OR IN LAW, INCLUDING WITHOUT LIMITATION THE WARRANTY OF MERCHANTABILITY OR THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THE LIMITED WARRANTY SET FORTH ABOVE. LIMITATIONS AND LIABILTY It is expressly understood and agreed that the limit of Thermal Pipe Systems, Inc. liability shall be the resupply of a like quantity of nondefective product and that Thermal Pipe Systems, Inc. shall have no such liability except where the damage or claim results solely from the breach of the Thermal Pipe Systems, Inc. warranty. IT IS ALSO AGREED THAT THERMAL PIPE SYSTEMS, INC. SHALL NOT BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL, OR OTHER DAMAGES FOR ANY ALLEGED NEGLIGENCE, BREACH OF WARRANTY, STRICT LIABILTY OR ANY OTHER THEORY, OTHER THAN THE LIMITED LIABILTY SET FORTH. ThermalPipeSystems,Inc. 5205 W. Woodmill Dr. Suite 33 – Wilmington, DE 19808 Tel: 302-999-1588 – Fax: 302-999-8861 Website: www.thermalpipesystems.com SUPER TEMP-TITE®