8 02/18 TRENCHING: Trenching shall follow the elevations provided by the design engineer on the contract drawings. The trench depth should always allow for a minimum cover height of 24" over the top of the casing pipe. Keep excavations free of water during construction. If the Contractor determines it is necessary to remove unsuitable material to a depth greater than specified, refill over excavated area to the proper depth with specified bedding material compacted in 6 inch lifts to 95 percent of maximum density in accordance with ASTM D1557, Method D. Excavate and replace soil disturbed and weakened by the contractor's operations or soils permitted to soften from exposure to weather, with bedding material and compact with a plate-type vibratory compactor. TRENCH WIDTHS: The width of the trench at the top of the pipe should be held to the minimum required for efficient and proper installation. The reason for this is to keep the earth load on the pipe as small as possible. The wider the trench at the top of the pipe, the greater the load on the pipe. Note that an increase in trench width above the top of the pipe, by stepping the sides or digging a wider offset trench, does not affect the earth load on the pipe. On the other hand, a trench that is too narrow will make assembly difficult and may reduce the rate and quality of installation. In addition, lack of ample room will limit the capability to properly backfill and tamp around the pipe. Although each job or portion of a job must be considered on an individual basis, as a rule, the following minimum trench widths at the top of the pipe are recommended: Minimum: one foot greater than the outside diameter of the casing. Where two or more pipes are in the same trench, use the distance between outside casing of the outside pipes plus one foot. Maximum: Use above method for minimum plus two feet. DISTRIBUTING PIPE ALONG TRENCH: Pipe lengths may be strung along the line of the trench to minimize additional handling during installation. PLACING PIPE IN THE TRENCH: The COPPER-CORE pipe may be hand or mechanically passed into the trench. The latest state and federal safety regulations should be understood and observed. If slings are necessary use only canvas straps, do not use cable or chain slings. BEDDING: Bedding material should be sand or other materials free of sharp objects, heavy clods, boulders or frozen lumps as specified by the design engineer. The approved bedding should be used 6" under, around and over the pipe. Utilize good practices that apply to buried pressure piping. ASSEMBLY: 1) Be sure all surfaces are clean and that the "o"-ring is properly seated in the bronze coupling. 2) Check that the exposed end of copper pipe is clean and does not have any nicks, burrs or scratches that could damage the rubber ring during assembly. The packaging is designed to protect these ends and should not be removed until pipe is ready to be installed.