1 02/18 TAPER-TITE 230 PIPING SYSTEMS SPECIFICATIONS TAPER-TITE 230 shall be used where specified for condensate, low temperature hot water, chilled water, or dual temp service. The pipe shall be joined with adhesive using matching tapered bell and spigot ends. Unless otherwise specified, all pipe, fittings, valves and accessories shall conform to the requirements of ANSI B31.1 and shall be of the proper type for pressure and temperature of the heating or cooling water. FRP CARRIER PIPE: Carrier Pipe shall be Fiberglass Reinforced Plastic (FRP) and shall be filament wound using epoxy resins. Pipe shall have a resin-rich, reinforced liner and comply with ASTM D2310, D2996, and D5686. Resin Designation Codes shall be RTRP-11FX1: 3110 for all sizes. The pipe shall be bell and spigot design in all sizes. CASING PIPE: The casing shall be [Polyvinyl Chloride (PVC)] pipe shall be of virgin PVC resin meeting the minimum classification requirements of ASTM D1784 or [High Density Polyethylene (HDPE)]. The thickness for PVC casing shall be as shown on page four. Consult manufacturer for HDPE dimensional data. RUBBER END SEALS: Rubber end seals for insulated TAPER-TITE shall be a high temperature heat resistant Ethylene Propylene Diene Monomer (EPDM) molded rubber compound. All surfaces shall be smooth and free of voids. POLYURETHANE FOAM INSULATION: The insulation shall be Polyurethane Foam and shall meet the following specifications: Type: Two component urethane Compressive Strength: 40 psi parallel min at 5% comp. Shrinkage: None at 70ºF Free Rise Density: 2.0 to 3.0 lbs./cubic foot Aged "K" (70ºF - 72 hrs) 0.16 BTU-in./hour-ºF-ft.2 Closed Cell Content: 90% Insulation concentricity: Carrier Pipe shall be concentric to casing pipe. The allowable maximum deviation from centerline of carrier pipe shall be plus or minus 1/4 inch at the casing center point and plus or minus 1/16 inch at the end seals. CASING-TITE SLEEVE: The Casing-Tite Sleeve shall be of virgin PVC Resin meeting classification requirements of ASTM D1784. CASING-TITE SEAL: The Casing-Tite Seal shall be 30 mil high temperature tape.